Semaphore Signal Drivers

Semaphore Signals Driver (Part Number 030-100)

This Module will Drive upto Four Separate Semaphore Signal Servos.

The outputs are standard Pulse-width modulation (PWM) used by RC Servos.

The output connectors are three-pin 0.1" spacing 0.025" square pins in the normal Signal, +5V, GND

format ready for standard servos. Link to our servos here

The inputs are normaly high logic inputs and control the two positions of the servo.

The inputs are on standard screw termails.

One further connector is provided for connection of the Driver Trimmer for

adjusting the Upper and Lower position, Bounce and Speed of the servo.

More information on the Trimmer here